Passive-Interface - Dell S6100 Configuration Manual

Version
7.8.1.0
7.6.1.0
pre- 6.2.1.1
Usage Information This command is intended for low-speed interfaces.

passive-interface

Suppress routing updates on a specified interface.
Syntax passive-interface interface
To delete a passive interface, use the no passive-interface interface command.
Parameters
interface
Defaults Not configured.
Command Modes ROUTER RIP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
Description
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Enter the following information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the stack/slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the
stack/slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/
slot/port[/subport] information.
• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/
slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the
stack/slot/port information.
• For a Port Channel interface, enter the keywords port-channel then a number.
• For a VLAN, enter the keyword vlan then a number from 1 to 4094.
Description
Introduced on the S6100-ON.
Introduced on the Z9100-ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Routing Information Protocol (RIP) 1335