Dell S6100 Configuration Manual page 1227

To delete all monitor sessions, use the no monitor session all command.
Parameters
session-ID
type
rpm
erpm
set ip dscp
dscp_value
set ip ttl
ttl_value
drop
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(2.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.8(0.0)
9.7(0.0)
9.5(0.1)
9.4(0.0)
9.0.2.0
9.0.2.0
8.3.11.1
8.3.7.0
Enter a session identification number. The range is from 0 to 65535.
Specifies one of the following type:
•
rpm
•
erpm
Creates a remote port monitoring (rpm) session.
Creates an encapsulated remote port monitoring (erpm) session.
Configures the Differentiated Services Code Point (DSCP) value of the packets in the
Encapsulated Remote Switched Port Analyzer (ERSPAN) traffic. To revert to the default
value, use the no form of this command.
DSCP value of the packets in the ERSPAN traffic. The range is from 0 to 63. The default
value is 0.
Configures the IP time-to-live (TTL) value of the Encapsulated Remote Switched Port
Analyzer (ERSPAN) traffic. To revert to the default configuration, use the no form of this
command.
IP TTL value of the ERSPAN traffic. The range is from 1 to 255. The default value is 255.
Monitors only the dropped packets in the Ingress.
Description
Introduced on the S6100-ON.
Introduced on the S3100 series.
Introduced on the Z9100-ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Added the drop parameter.
Introduced on the S6000-ON. Introduced the set ip dscp and set ip ttl
parameters.
Introduced on the Z9500.
Introduced on the S4810, S4820T, S6000, and Z9000.
Introduced on the S6000.
Introduced on the MXL.
Introduced on the Z9000.
Introduced on the S4810.
Port Monitoring 1227