Ip Local-Proxy-Arp - Dell S6100 Configuration Manual

• A trunk port can also belong to a regular VLAN (non-private VLAN).
Topics:
•

ip local-proxy-arp

• private-vlan mode
• private-vlan mapping secondary-vlan
• switchport mode private-vlan
ip local-proxy-arp
Enable/disable Layer 3 communication between secondary VLANs in a private VLAN.
Syntax [no] ip local-proxy-arp
To disable Layer 3 communication between secondary VLANs in a private VLAN, use the no ip local-proxy-
arp command in INTERFACE VLAN mode for the primary VLAN.
To disable Layer 3 communication in a particular secondary VLAN, use the no ip local-proxy-arp
command in INTERFACE VLAN mode for the selected secondary VLAN.
Defaults Layer 3 communication is disabled between secondary VLANs in a private VLAN.
Command Modes INTERFACE VLAN
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
NOTE: Even after you disable ip-local-proxy-arp (use no ip-local-proxy-arp) in a
secondary VLAN, Layer 3 communication may happen between some secondary VLAN hosts, until the
address resolution protocol (ARP) timeout happens on those secondary VLAN hosts.
Description
Introduced on the S6100-ON.
Introduced on the Z9100-ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the C-Series and S-Series.
Private VLAN (PVLAN) 1235