Rate-Limit - Dell S6100 Configuration Manual

Usage Information The monitor command is saved in the running configuration at Monitor Session mode level and can be restored
after a chassis reload.
Example
Dell# show monitor session
Related Command
•
•

rate-limit

Configure the rate-limit to limit the mirrored packets.
Syntax rate-limit limit
To remove the limit, use the no rate-limit limit command.
Parameters
limit
Defaults 60
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.8(0.0)
Related Commands
•
•
show config
Display the current monitor session configuration.
Syntax show config
Defaults none
Command Modes MONITOR SESSION (conf-mon-sess-session-ID)
1228 Port Monitoring
SessID Source Destination
------ ------ -----------
0 Te 1/1/2/1
0 Po 1
1 Vl 11
show monitor session — displays the monitor session.
show running-config monitor session
Enter the rate-limit value. The range is from 0 to 40000 Megabits per second.
Description
Introduced on the S6100-ON.
Introduced on the Z9100-ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S4810, S4820T, S5000, S6000, S6000-ON, Z9500.
monitor session — enable a monitoring session.
show monitor session — display the monitor session.
Dir Mode
--- ----
remote-ip rx Flow 1.1.1.1
remote-ip tx Flow 1.1.1.1
remote-ip rx Flow 5.1.1.1
— displays the running configuration of a monitor session.
Source IP Dest IP
--------- --------
7.1.1.2
7.1.1.2
3.1.1.2
DSCP TTL
---- ---
0 255
0 255
0 255