Policy-based routing (PBR) allows you to apply routing policies to specific interfaces. To enable PBR, create a redirect list and apply it to the
interface. After the redirect list is applied to the interface, all traffic passing through the interface is subject to the rules defined in the
redirect list. PBR is supported by the Dell Networking OS.
You can apply PBR to physical interfaces and logical interfaces (such as a link aggregation group [LAG] or virtual local area network
[VLAN]). Trace lists and redirect lists do not function correctly when you configure both in the same configuration.
NOTE:
Apply PBR to Layer 3 interfaces only.
NOTE:
For more information , see
Topics:
•
description
•
ip redirect-group
•
ip redirect-list
•
permit
•
redirect
•
seq
•
show cam pbr
•
show ip redirect-list
description
Add a description to this redirect list.
Syntax
description {description}
To remove the description, use the no description {description} command.
Parameters
description
Defaults
None
Command Modes
REDIRECT-LIST
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
Policy-based Routing (PBR)
Content Addressable Memory
Enter a description to identify the IP redirect list (16 characters maximum).
Description
Introduced on the S6100-ON.
(CAM).
Policy-based Routing (PBR)
37
1187