Show Monitor Session - Dell S6100 Configuration Manual

Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.5(0.1)
9.0.2.0
8.3.19.0
8.3.7.0
8.3.11.1
8.1.1.0
7.7.1.0
7.5.1.0
7.4.1.0
Example
Dell(conf-mon-sess-1)# show config
!
monitor session 1
source TenGigabitEthernet 1/1/1/1 destination Port-channel 1 direction rx

show monitor session

Display information about monitoring sessions.
Syntax show monitor session {session-ID}
To display monitoring information for all sessions, use the show monitor session command.
Parameters
session-ID
Defaults none
Command Modes
•
•
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.11(0.0)
Description
Introduced on the S6100-ON.
Introduced on the Z9100-ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Introduced on the E-Series.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
(OPTIONAL) Enter a session identification number. The range is from 0 to 65535.
EXEC
EXEC Privilege
Description
Introduced the support for GRE Protocol and FC Monitor in the command output.
Port Monitoring 1229