Ip Rip Send Version - Dell S6100 Configuration Manual

ip rip send version

To send a specific version of RIP, set the interface. The version you set on the interface overrides the version command in ROUTER RIP
mode.
Syntax ip rip send version [1] [2]
To return to the default value, use the no ip rip send version command.
Parameters
1
2
Defaults RIPv1
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.6.1.0
pre- 6.2.1.1
Usage Information To enable the interface to send both version of RIP packets, use the ip rip send version 1 2 command.
Related Commands
•
•
1328 Routing Information Protocol (RIP)
(OPTIONAL) Enter the number 1 for RIP version 1. The default is RIP version 1.
(OPTIONAL) Enter the number 2 for RIP version 2.
Description
Introduced on the S6100-ON.
Introduced on the Z9100-ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
ip rip receive version — sets the RIP version for the interface to receive traffic.
version — sets the RIP version for the switch software.