Default-Metric - Dell S6100 Configuration Manual

route-map map-
name
Defaults Disabled. Metric: 1.
Command Modes ROUTER RIP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.6.1.0
pre- 6.2.1.1
Usage Information The default route must be present in the switch routing table for the default-information originate
command to take effect.

default-metric

Change the default metric for routes. To ensure that all redistributed routes use the same metric value, use this command with the
redistribute command.
Syntax default-metric number
To return the default metric to the original values, use the no default-metric command.
Parameters
number
Defaults 1
Command Modes ROUTER RIP
1320 Routing Information Protocol (RIP)
(OPTIONAL) Enter the keywords route-map then the name of a configured route-map.
Description
Introduced on the S6100-ON.
Introduced on the Z9100-ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Specify a number. The range is from 1 to 16. The default is 1.