Disable; Garp Timers - Dell S4810 Reference Manual

disable

Globally disable GVRP.
S4810
Syntax
disable
To re-enable GVRP, use the no disable command.
Defaults Enabled.
Command CONFIGURATION-GVRP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Related
gvrp enable
Commands
protocol gvrp

garp timers

Set the intervals (in milliseconds) for sending GARP messages.
S4810
Syntax
garp timers {join | leave | leave-all}
To return to the previous setting, use the no garp timers {join | leave |
leave-all} command.
Parameters
join
684
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on C-Series, E-Series, and S-Series
— enables GVRP on physical interfaces and LAGs.
— access GVRP protocol.
Enter the keyword join then the number of milliseconds to
configure the join time. The range is from 100 to 147483647
milliseconds. The default is 200 milliseconds.
GARP VLAN Registration (GVRP)