Garp Timers - Dell Z9500 Command Reference Manual

garp timers

Set the intervals (in milliseconds) for sending GARP messages.
Z9500
Syntax
garp timers {join | leave | leave-all}
To return to the previous setting, use the no garp timers {join | leave |
leave-all} command.
Parameters
join
leave
leave-all
Defaults As above.
Command CONFIGURATION-GVRP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
796
Enter the keyword join then the number of milliseconds to
configure the join time. The range is from 100 to 147483647
milliseconds. The default is 200 milliseconds.
NOTE: Designate the milliseconds in multiples of 100.
Enter the keyword leave then the number of milliseconds
to configure the leave time. The range is from 100 to
2147483647 milliseconds. The default is 600 milliseconds.
NOTE: Designate the milliseconds in multiples of 100.
Enter the keywords leave-all then the number of
milliseconds to configure the leave-all time. The range is
from 100 to 2147483647 milliseconds. The default is 1000
milliseconds.
NOTE: Designate the milliseconds in multiples of 100.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on C-Series, E-Series, and S-Series
GARP VLAN Registration (GVRP)