Installation: Task 6 - Finalize And Test The Hardware - Avaya DEFINITY Manual

Installation: Task 6 — Finalize and Test the Hardware
Installation: Task 6 — Finalize and Test
the Hardware
This task is required for all installation scenarios to verify that the MAPD system
hardware and software components are installed properly.
1. At the DEFINITY G3-MT, enter list configuration board <loc>.
The DEFINITY system displays the System Configuration Screen with
columns (fields) for Board Number, Board Type, Code, and so on.
2. From the System Configuration screen, check under Board Type for
MAPD BOARD ; under Code you should see TN801B (which corresponds to
the MAPD board entry).
3. At the front panel of the MAPD circuit pack, verify that the LCD displays
ASAI along with the number of established links. For example ASAI 8 .
This confirms that the MAPD system is in the ASAI state with 8 links.
4. From the MAPD terminal verify that the terminal and modems (if
applicable) are connected and set up correctly.
5. At the login prompt, type craft and press Return. (If the login prompt is
not displayed, press Return once or twice.)
6. Enter the default password for the craft login.
7. Enter one of the following:
NOTE:
To send the information to the MAPD system, press Return (located
on the right side of your keyboard) after you type a command, or a
response to a prompt. On some keyboards, this key is labeled Enter
instead of Return If your keyboard has both Return and Enter (as on
the 513 and 615 keyboards), use Return.
System response: Password
System response: Terminal Type (513, 715, 4410,
4425,vt100, vt220,...): [xterm]
513 for a 513 BCT or 715 BCT; enter 513 also for a 610/615 BCT or
a PC with a 513 emulation package. (Since 513 is the default, just
press Return to select it.)
4410 for a 4410 or 5410 terminal; enter 4410 also for a 610/615
BCT or a PC with a 4410 emulation package.
4425 for a 4425 or 5425 terminal
5420 for a 5420 or 4415 terminal
g3-ma for a G3-MA terminal
vt220 (or other terminal listed in Appendix B,
Terminals/Modems")
"Worksheet B-1:
Issue 3 May 2002 2-37