Pri Test Commands - Avaya CS 1000 Maintenance Manual

Primary Rate Interface maintenance
Command
LCNT
LCNT L
RSET L CH
RCNT
RCNT L

PRI test commands

See Table 12: PRI test commands in LD 60
and a corresponding description of these commands. The PRI test commands are in LD 60.
Table 12: PRI test commands in LD 60
Command
ATLP (0) 1
SLFT L
SLFT L CH
42 ISDN Primary Rate Interface Maintenance
Prints content of all alarm counters of all PRI loops.
Prints content of all alarm counters of PRI loop L. The counters are:
BPV Bipolar violation bit error rate counter. Indicates the number of times
the loop has entered state due to excessive bipolar violations.
FAP Number of times the loop has entered state due to excessive frame
bit errors.
SLP Frame slip repetition counter. The number of times the loop has
entered state due to excessive frame slips.
CRC Cyclic Redundancy Check (CRC) bit error rate counter. The number
of times the loop has entered state due to CRC frame errors.
G2 The number of times the loop has entered state due to excessive
group 2 errors.
TOTAL 24 HOUR BPV 24-hour bit error rate count
TOTAL 24 HOUR FAP 24-hour frame bit error rate count
TOTAL 24 HOUR SLP 24-hour slip count
TOTAL 24 HOUR CRC 24-hour CRC error count
TOTAL 24 HOUR G2 AIS 24-hour alarm indication signal count
TOTAL 24 HOUR G2 LFAS 24-hour loss of frame alignment count
TOTAL 24 HOUR G2 LMAS 24-hour loss of multiframe alignment count
TOTAL 24 HOUR G2 RAI 24-hour remote alarm indication count
TOTAL 24 HOUR G2 LOS 24-hour loss of signal count
Resets the thresholds for PRI loop L, trunk channel CH.
Resets all alarm counters of all PRI loops.
Resets all alarm counters of PRI loop L.
Automatic loop test enable (= 1) or disable (= 0) default.
1 = Loop test enable; this will cause far end to raise and clear remote
alarm.
0 = Run the partial loop test; there is no interaction for the far-end loop
(default value).
Invokes PRI self-test on loop L. The loop must be disabled because the
test disrupts call processing.
Invokes partial PRI hardware self-test using channel CH of loop L.
Comments? infodev@avaya.com
Description
on page 42 for a list of the PRI test commands
Description
November 2011