Renault Laguna III Manual page 2505

Distribution unit: Removal - Refitting
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Unclip the rear air distribution ducts (9) from the dis-
tribution unit.
a Disconnect the connector (10) .
a Move the electrical wiringto one side.
a Remove the distribution unit.
a Remove the following components from the distribu-
tion unit:
- the cabin filter,
- the passenger compartment blower unit,
HEATING
- the heater matrix,
- the heating resistor relay housing,
- the heating resistor,
- the passenger compartment blower unit control
unit,
- the recirculation motor,
- the demisting motor,
- the air mixing motor,
- the distribution motor,
- the toxicity sensor,
- the evaporator sensor,
- the climate control computer.
REFITTING
I - REFITTING PREPARATION OPERATION
a Always replace the connecting pipe seals.
122529
a Refit the following components onto the distribution
unit:
- the cabin filter,
- the passenger compartment blower unit,
- the heater matrix,
- the heating resistor relay housing,
- the heating resistor,
- the passenger compartment blower unit control
unit,
- the recirculation motor,
- the demisting motor,
- the air mixing motor,
- the distribution motor,
- the toxicity sensor,
- the evaporator sensor,
- the climate control computer.
122545
II - REFITTING OPERATION FOR PART
CONCERNED
a Refit the distribution unit.
a Fit the electrical wiring.
a Connect the connector (10) .
a Clip the rear air distribution ducts onto the distribu-
tion unit.
61A-8
61A