Show Dot1X Interface - Allied Telesis x510-28GTX Command Reference Manual

802.1X C
OMMANDS
1
SHOW DOT X INTERFACE

show dot1x interface

Overview This command shows the status of 802.1X port-based authentication on the
specified interface, which may be a static channel (or static aggregator) or a
dynamic (or LACP) channel group or a switch port.
Use the optional diagnostics parameter to show authentication diagnostics for
the specified interfaces. Use the optional sessionstatistics parameter to show
authentication session statistics for the specified interfaces. Use the optional
statistics parameter to show authentication diagnostics for the specified
interfaces. Use the optional supplicant parameter to show the supplicant state for
the specified interfaces.
For information on filtering and saving command output, see the
with AlliedWare_Plus" Feature Overview and Configuration
Syntax show dot1x interface <interface-list>
[diagnostics|sessionstatistics|statistics|supplicant [brief]]
Mode Privileged Exec
Examples See the sample output below showing 802.1X authentication status for
port1.0.6:
awplus#
C613-50170-01 Rev B
Parameter
<interface-list>
diagnostics
sessionstatistics
statistics
supplicant
brief
show dot1x interface port1.0.6
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
The interfaces or ports to configure. An interface-list can be:
• an interface (e.g. vlan2), a switch port (e.g.
port1.0.6), a static channel group (e.g. sa2) or a
dynamic (LACP) channel group (e.g. po2)
• a continuous range of interfaces, ports, static channel
groups or dynamic (LACP) channel groups separated by a
hyphen; e.g. vlan2-8, or port1.0.1-1.0.4, or
sa1-2, or po1-2
• a comma-separated list of the above; e.g.
port1.0.1,port1.0.3-1.0.5. Do not mix
interface types in a list
The specified interfaces must exist.
Diagnostics.
Session Statistics.
Statistics.
Supplicant.
Brief summary of supplicant state.
"Getting Started
Guide.
1702