Bundled-Group-Id-Overrides-Mlppp-Ed - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
JunosE 11.2.x Command Reference Guide A to M
bundled-group-id-overrides-mlppp-ed
Syntax
Release Information
Description
Mode
344
[ no ] bundled-group-id-overrides-mlppp-ed
Command introduced before JunosE Release 7.1.0.
Specifies that the router uses the bundled group identifier you assigned using the
bundled-group-id command when selecting a tunnel-service module instead of any
endpoint discriminator. The no version removes the override.
NOTE: We strongly recommend that you use this command only with the support of
JTAC.
L2TP Destination Profile Host Configuration
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
