Clear Bgp Ipv6 Dampening - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

JunosE 11.2.x Command Reference Guide A to M

clear bgp ipv6 dampening

Syntax
Release Information
Description
Options
362
To clear IPv6-specific information for only the route-target address family:
clear bgp ipv6 route-target signaling
{ dampening | flap-statistics } [ rtfPrefix | rtfAddress ]
To clear IPv6-specific information for any case other than for the route-target address
family:
clear bgp ipv6 [ vrf vrfName ] [ unicast | multicast | vpnv6 ]
{ dampening | flap-statistics } [ ipv6Prefix ]
Command introduced before JunosE Release 7.1.0.
route-target signaling keywords and rtMemNlri variable added in JunosE Release 8.2.0.
rtMemNlri variable replaced by two variables, rtfAddress and rtfPrefix, in JunosE Release
9.1.0.
Clears IPv6-specific BGP route flap dampening information and reinstates the suppressed
routes. If the ipv6Prefix option is not used, clears the entire IPv6 BGP routing table. The
dampening keyword and the flap-statistics keyword both have the same effect. There
is no no version.
route-target signaling—Clears the route-target membership information
rtfPrefix—Prefix representing the route-target membership NLRI (RT-MEM-NLRI), in
the format asNumber : extendedCommunity / prefixLength (for example,
320:320:524/36) where:
asNumber—AS number for origin of route target information, in the range
1–4294967295
extendedCommunity—Two-part number in the format number1:number2 that identifies
an extended community of VPNs, in the format number1 : number2, where:
number1—Autonomous system (AS) number, in the range 1–4294967295, or an IP
address
number2—Unique integer, in the range 1–4294967295; 32 bits if number1 is a 16-bit
AS number; 16 bits if number1 is an IP address or a 32-bit AS number
prefixLength—Number that specifies the length of the route prefix, in the range 32–96
rtfAddress—rtfPrefix with a prefix length of 96; representing the route-target
membership NLRI (RT-MEM-NLRI), in the format asNumber: extendedCommunity (for
example, 320:320:524 or 320:50.2.3.4:524)
vrfName—Name of a virtual routing and forwarding instance to clear
unicast—Clears the unicast routing table; the default option
multicast—Clears the multicast routing table
Copyright © 2010, Juniper Networks, Inc.