Clear Bridge Interface - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

clear bridge interface

Syntax
Release Information
Description
Options
Mode
Related Topics
Copyright © 2010, Juniper Networks, Inc.
clear bridge interface interfaceType interfaceSpecifier
Command introduced before JunosE Release 7.1.0.
Removes from the forwarding table all dynamic (learned) MAC address entries for a
specified network interface that belongs to a bridge group or to a VPLS instance . There
is no no version.
NOTE: Using the clear bridge interface command for a VPLS instance affects the
specified network interface associated with the VPLS instance, but has no effect on
the VPLS virtual core interface, which represents all of the MPLS tunnels from the router
to the remote VPLS edge (VE) devices. To remove all MAC addresses from the
forwarding table for the VPLS virtual core interface, use the clear bridge interface vpls
command.
interfaceType—One of the following interface types listed in "Interface Types and
Specifiers" on page 5
atm
fastEthernet
gigabitEthernet
tenGigabitEthernet
interfaceSpecifier—Particular interface; format varies according to interface type; see
Interface Types and Specifiers on page 5
Privileged Exec
Clearing Dynamic MAC Addresses from the VPLS Forwarding Table in the JunosE BGP
and MPLS Configuration Guide
Chapter 4: C Commands
369