Clear Ip Bgp Wait-End-Of-Rib - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

clear ip bgp wait-end-of-rib

Syntax
Release Information
Description
Options
Mode
Related Topics
Copyright © 2010, Juniper Networks, Inc.
clear ip bgp [ ipAddress | ipv6Address | peer-group peerGroupName
| * ] [ vrf vrfName ]
[ ipv4 unicast | ipv4 multicast | vpnv4 unicast | l2vpn all | l2vpn vpls vplsName |
l2vpn vpws vpwsName | route-target signaling ] wait-end-of-rib
Command introduced before JunosE Release 7.1.0.
l2vpn keyword added in JunosE Release 7.1.0.
ipv6Address variable added in JunosE Release 8.0.0.
route-target signaling keywords added in JunosE Release 8.2.0.
all, vpls, and vpws keywords and vplsName and vpwsName variables added in JunosE
Release 9.3.0.
Brings down the underlying TCP connection and then brings it back up again, causing
both peers to resend their complete BGP routing table, but clears the specified peer from
the set of peers for which BGP is waiting to receive an End-of-RIB marker after a peer
restart. Hard clearing a peer has the same effect for that peer. There is no no version.
ipAddress—IP address of identified BGP neighbor to clear
ipv6Address—IPv6 address of identified BGP neighbor to clear
peerGroupName—Name of a BGP peer group to clear
*—Clears all connections
vrfName—Name of a virtual routing and forwarding instance to clear
ipv4 unicast—Clears the IPv4 unicast routing table; the default option
ipv4 multicast—Clears the IPv4 multicast routing table
vpnv4 unicast—Clears the VPNv4 unicast routing and forwarding table
l2vpn all—Clears the L2VPN reachability information for all VPLS and VPWS instances
in the L2VPN address family
l2vpn vpls vplsName—Clears the L2VPN reachability information for the VPLS instance
with the name vplsName
l2vpn vpws vpwsName—Clears the L2VPN reachability information for the VPWS
instance with the name vpwsName
route-target signaling—Clears the route-target membership information
Privileged Exec
Clearing BGP Attributes for L2VPNs and Clearing BGP Attributes for VPLS in the JunosE
BGP and MPLS Configuration Guide
Chapter 4: C Commands
379