Clear Ip Bgp Dampening - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

Software for e series broadband services routers command reference a to m
Hide thumbs Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
Table of Contents

Advertisement

clear ip bgp dampening

Syntax
Release Information
Description
Options
Copyright © 2010, Juniper Networks, Inc.
To clear IP-specific information for only the route-target address family:
clear ip bgp route-target signaling { dampening | flap-statistics } [ rtfPrefix
| rtfAddress ]
To clear IP-specific information for any case other than for the route-target address
family:
clear ip bgp
[ vrf vrfName ] [ ipv4 unicast | ipv4 multicast | vpnv4 unicast |
l2vpn all | l2vpn vpls vplsName | l2vpn vpws vpwsName]
{ dampening | flap-statistics } [ ipAddress [ addressMask ] ]
Command introduced before JunosE Release 7.1.0.
l2vpn keyword added in JunosE Release 7.1.0.
vpls keyword and vplsName variable added in JunosE Release 7.1.0.
all, vpws, and route-target signaling keywords and rtMemNlri and vpwsName variables
added in JunosE Release 8.2.0.
rtMemNlri variable replaced by two variables, rtfAddress and rtfPrefix, in JunosE Release
9.1.0.
Clears IP route flap dampening information and reinstates the suppressed routes. The
dampening keyword and the flap-statistics keyword both have the same effect. There
is no no version.
route-target signaling—Clears the route-target membership information
rtfPrefix—Prefix representing the route-target membership NLRI (RT-MEM-NLRI), in
the format asNumber : extendedCommunity / prefixLength (for example,
320:320:524/36) where:
asNumber—AS number for origin of route target information, in the range
1–4294967295
extendedCommunity—Two-part number in the format number1:number2 that identifies
an extended community of VPNs, in the format number1 : number2, where:
number1—Autonomous system (AS) number, in the range 1–4294967295, or an IP
address
number2—Unique integer, in the range 1–4294967295; 32 bits if number1 is a 16-bit
AS number; 16 bits if number1 is an IP address or a 32-bit AS number
prefixLength—Number that specifies the length of the route prefix, in the range 32–96
rtfAddress—rtfPrefix with a prefix length of 96; representing the route-target
membership NLRI (RT-MEM-NLRI), in the format asNumber: extendedCommunity (for
example, 320:320:524 or 320:50.2.3.4:524)
vrfName—Name of a virtual routing and forwarding instance to clear
Chapter 4: C Commands
375

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.2

Table of Contents