Check-Disk - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
check-disk
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
check-disk [ repair ] [ disk0 | disk1 ]
Command introduced before JunosE Release 7.1.0.
disk0 and disk1 keywords added in JunosE Release 7.2.0.
Privileged Exec mode added in JunosE Release 8.0.0.
Finds and repairs structural inconsistencies and damage in the DOS file system in
unmounted flash cards on the primary SRP module. There is no no version.
disk0—Specifies flash card in slot 0 of the SRP module; default value is disk0; available
only in Boot mode, because disk0 cannot be in an unmounted state in a router outside
of Boot mode
disk1—Specifies flash card in slot 1 of the SRP module; supported only on the E120
router and the E320 router
Boot, Privileged Exec
Chapter 4: C Commands
351
Advertisement
Table of Contents
