Bulkstats Schema Subtree - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

bulkstats schema subtree

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
bulkstats schema schemaIndex subtree
{ if-stack | if-stats { subtreelist [ ifstatsList [ ifstatsList ]* ] |
if-create-delete-time-stats interfaceType interfaceType } | igmp | system }
bulkstats schema schemaIndex subtree
{ if-stack | if-stats | igmp [ subtreelist igmpList [ igmpList ]* ] | system }
no bulkstats schema schemaIndex
Command introduced before JunosE Release 7.1.0.
mplsL2shim, mplsMajor, and mplsMinor keywords added in JunosE Release 8.2.0.
Configures the schema for collecting if-stack, if-stats, or router data. The no version
removes the schema.
schemaIndex—Identifier for the schema in the range 1–65535
if-stack—Retrieves ifStackTable
if-stats—Retrieves ifTable/ifXTable counters
ifstatsList—Type of statistics and time-offset keyword, which includes the offset from
the master interval at which the record was collected in each bulkstats interface record
if-create-delete-time-stats—Retrieves interface final statistics (interface statistics
that may be lost during higher create or delete frequency)
interfaceType—One of the following interface types for which you can collect statistics:
ATM 1483, IP, MPLS minor, MPLS major, MPLS shim, PPP
igmp—Retrieves IGMP statistics
igmpList—Type of statistics and time-offset keyword, which includes the offset from
the master interval at which the record was collected in each bulkstats interface record
system—Retrieves sysUpTime and nvsUtilPct global statistics; retrieves slotDescr, the
cpuUtilPct, and memUtilPct per-slot statistics
*—Indicates that one or more parameters can be repeated multiple times in a list in
the command line
Global Configuration
Chapter 3: B Commands
337