Table of Contents
Advertisement
Accessing the Control Terminal Port
Introduction
Once you have powered on the PathBuilder S21x switch, you can access the Control
Terminal Port from the PC or terminal attached to the CTP port.
Procedure
Follow these steps to access the PathBuilder S21x switch CTP Main menu:
CTP Access Via
Another way to connect to the CTP, after the node is configured and operational, is to
Remote Telnet
access remotely via your established IP network by telneting into the node from an
IP network-based personal computer or workstation. You can connect to the CTP by
entering atds0 <CR> after the PathBuilder S21x switch outputs the OK prompt.
CTP Access Via
If the PathBuilder S21x switch is operating in an X.25 network, or if Frame Relay
Remote X.25 or
Annex-G is used to connect with other 3Com PathBuilder S200 series switches, you
Frame Relay
can access the PathBuilder S200 series switch CTP remotely by making a Switched
Network
Virtual Circuit (SVC) call to the node and specifying subaddress 98.
Powering on the PathBuilder S21x Switch
All manuals and user guides at all-guides.com
Note
This section does not provide all information about accessing the CTP. For more
information on accessing and using the CTP refer to the Basic Configuration
Manual (Part Number T0113).
Note
This procedure assumes that a PC or terminal is connected to the PathBuilder
S21x switch using the CTP access cable.
Step
1
Set your terminal, or terminal emulation software, to VT100, 9600 bps,
8 bit, no parity, 1 stop bit.
2
Type
until either an asterisk (*) or the OK prompt appears.
<CR>
3
When you see OK, type
.ctp.
The CTP banner will appear. If this banner does not appear, verify that
these steps have been followed correctly.
4
Type
at the password prompt, if no password has been set.
<CR>
Accessing the Control Terminal Port
Action
. When you see the asterisk (*) type
atds0 <CR>
3-5
Advertisement
Table of Contents
