Installing The Switch; Installation Flow Of The Switch - 3Com 4210G Series Getting Started Manual

3

Installing the Switch

When you ask your sales agent to maintain the switch, you must ensure that the
dismantlement-preventive seal on a mounting screw of the 3Com switch chassis is intact. If you want to
open the chassis, you should contact the agent for permission. Otherwise, you will bear any
consequence resulted from your actions without permission.

Installation Flow of the Switch

Figure 3-1 Hardware installation flow of the switch
Start
Install the switch to the
specified position
Connect the ground wire
Hot swappable power
module needed？
Connect the power cord
Verify the Installation
Power on the switch
Operates normally？
No
Install Interface cards？
Install the Interface card
Operates normally？
Install the transceivers and
cables
Yes
Select and Install the
No
power module
Troubleshoot
No
Power off the switch
Yes
Yes
No
Troubleshoot
Yes
End
3-1