Display Uni Signaling Timers - 3Com CoreBuilder 9000 User Manual

200 C 7: C
HAPTER ONFIGURING
Display UNI Signaling
Timers
V C
IRTUAL HANNELS
Display the current Q93B signaling timer values in seconds. These values
are the same for all ports because they all work on a common timer. Enter
any port identifier. To alter these values, update the timer resolution. For
more information, see "Update Protocol Timer Resolution" on page 199.
Command Actions
Enter the menu sequence: (1) SYS: Platform configuration
Enter a parameter at the prompt
Parameter
Port number
Direct access sequence:
Command Result
System action taken:
System message display:
(1) SET: Switch setup
(4) SIG: Signaling setup
(2) TMR: Get Signaling Q93B timers
Format or Range
<slot.group.port>
1 1 4 2 [parameters]
The current Q93B Signaling timers for all ports are
displayed in seconds.
Information is displayed as shown in the example.