Display Saved-Configuration - 3Com S7906E Command Reference Manual

Parameters
dest-addr: IP address or name of a TFTP server. The address cannot be an IPv6 address.
dest-filename: Target filename used to save the startup configuration file for the next system startup on
the server.
Description
Use the backup startup-configuration command to backup the startup configuration file (used at the
next system startup) using a filename you specify. If you do not specify this filename, the original
filename is used. This command only backs up the startup configuration file of the AMB.
Presently, the device uses TFTP to back up configuration files.
Examples
# Back up the startup configuration file of the device to the TFTP server with IP address 2.2.2.2, using
filename 192-168-1-26.cfg.
<Sysname> display startup
Current startup saved-configuration file:
Next startup saved-configuration file:
<Sysname> backup startup-configuration to 2.2.2.2 192-168-1-26.cfg
Backup next startup-configuration file to 2.2.2.2, please wait...
finished!
<Sysname>
After the above operation, the device backs up file test.cfg to TFTP server 2.2.2.2, where the file is
saved as 192-168-1-26.cfg.

display saved-configuration

Syntax
display saved-configuration [ by-linenum ]
View
Any view
Default Level
2: System level
Parameters
by-linenum: Identifies each line of displayed information with a line number.
Description
Use the display saved-configuration command to display the contents of the current configuration file
saved on the storage medium of the device.
After the device is powered on, if you find that some configurations are not validated or incorrect, you
may use this command to display the configuration used for the current startup. During device
management and maintenance, you can also use this command to check whether important
configurations are saved to the current configuration file.
flash:/config.cfg
flash:/test.cfg
1-16