Display Diagnostic-Information - 3Com S7906E Command Reference Manual

# Display the configuration from the line containing "user-interface" to the last line in the current
validated configuration (the output information depends on the device model and the current
configuration).
<Sysname> display current-configuration | begin user-interface
user-interface aux 0
user-interface vty 0 4
authentication-mode none
user privilege level 3
#
return

display diagnostic-information

Syntax
display diagnostic-information
View
Any view
Default Level
1: Monitor level
Parameters
None
Description
Use the display diagnostic-information command to display or save the statistics of each module's
running status in the system.
When the system is out of order, you need to collect a lot of information to locate the problem. At this
time you can use the display diagnostic-information command to display or save the statistics of
each module's running status in the system. The display diagnostic-information command collects
prompt information of the commands display clock, display version, display device, and display
current-configuration.
Examples
# Save the statistics of each module's running status in the system.
<Sysname> display diagnostic-information
Save or display diagnostic information (Y=save, N=display)?[Y/N]y
Please input the file name(*.diag)[flash:/default.diag]:aa.diag
Diagnostic information is outputting to flash:/aa.diag.
Please wait...
Save succeeded.
You can view the content of the file aa.diag by executing the more.aa.diag command in user view, in
combination of the <Page Up> and <Page Down> keys.
# Display the statistics of each module's running status in the system.
<Sysname> display diagnostic-information
1-9