3Com S7906E Command Reference Manual page 2007

* will be prosecuted to the maximum extent possible under the applicable law.*
******************************************************************************
Welcome to legal (header legal)
Press Y or ENTER to continue, N to exit.
Welcome to motd(header motd)
Welcome to shell(header shell)
<Sysname>
hotkey
Syntax
hotkey { CTRL_G | CTRL_L | CTRL_O | CTRL_T | CTRL_U } command
undo hotkey { CTRL_G | CTRL_L | CTRL_O | CTRL_T | CTRL_U }
View
System view
Default Level
2: System level
Parameters
CTRL_G: Assigns the hot key <Ctrl+G> to a command.
CTRL_L: Assigns the hot key <Ctrl+L> to a command.
CTRL_O: Assigns the hot key <Ctrl+O> to a command.
CTRL_T: Assigns the hot key <Ctrl+T> to a command.
CTRL_U: Assigns the hot key <Ctrl+U> to a command.
command: The command line associated with the hot key.
Description
Use the hotkey command to assign a hot key to a command line.
Use the undo hotkey command to restore the default.
By default, the system specifies corresponding commands for <Ctrl+G>, <Ctrl+L> and <Ctrl+O>, while
the others are null.
<Ctrl+G> corresponds to display current-configuration
<Ctrl+L> corresponds to display ip routing-table
<Ctrl+O> corresponds to undo debugging all
You can customize this scheme as needed however.
Examples
# Assign the hot key <Ctrl+T> to the display tcp status command.
<Sysname> system-view
1-16