Configuring Mpls Ldp; Mpls Ldp Configuration Task List - 3Com S7906E Configuration Manual

To do...
Configure a static LSP taking
the current LSR as the ingress
Configure a static LSP taking
the current LSR as a transit
LSR
Configure a static LSP taking
the current LSR as the egress
If you specify the next hop when configuring a static LSP, and the address of the next hop is
present in the routing table, you also need to specify the next hop when configuring the static IP
route.
The value of the next-hop-addr argument cannot be any local public network IP address.
For information about configuring a static IP route, refer to Static Routing Configuration in the IP
Routing Volume.

Configuring MPLS LDP

Configuration Prerequisites
Before configuring LDP, be sure to complete the following task:
Configuring MPLS basic capability.

MPLS LDP Configuration Task List

Complete the following tasks to configure LDP:
Configuring MPLS LDP Capability
Configuring Local LDP Session Parameters
Configuring Remote LDP Session Parameters
Configuring the Policy for Triggering LSP Establishment
Configuring the Label Distribution Control Mode
Configuring LDP Loop Detection
Configuring LDP MD5 Authentication
Use the command...
static-lsp ingress lsp-name
destination dest-addr { mask |
mask-length } nexthop
next-hop-addr out-label
out-label
static-lsp transit lsp-name
incoming-interface
interface-type interface-number
in-label in-label nexthop
next-hop-addr out-label
out-label
static-lsp egress lsp-name
incoming-interface
interface-type interface-number
in-label in-label
Task
1-20
Remarks
Optional
Optional
Optional
Remarks
Required
Optional
Optional
Optional
Optional
Optional
Optional