Reset Saved-Configuration - 3Com Switch 4500 Family Manual

View
Any view
Parameters
by-linenum: Displays configuration information with line numbers.
Description
Use the display this command to display the current configuration performed in the current view. To
verify the configuration performed in a view, you can use this command to display the parameters that
are valid in the current view.
Note that:
Effective parameters that are the same as the default are not displayed.
The configured parameter whose corresponding function does not take effect is not displayed.
Execution of this command in any user interface view or VLAN view displays the valid configuration
parameters in all user interfaces or VLANs.
Related commands: save, reset saved-configuration, display saved-configuration, display
current-configuration.
Examples
# Display the configuration parameters that take effect in all user interface views.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] user-interface aux 0
[Sysname-ui-aux0] display this
#
user-interface aux 0 4
idle-timeout 0 0
user-interface aux 5 7
user-interface vty 0
authentication-mode none
user privilege level 3
set authentication password simple 123
idle-timeout 0 0
user-interface vty 1 4
authentication-mode none
user privilege level 3
set authentication password simple 1
idle-timeout 0 0
#
return

reset saved-configuration

Syntax
reset saved-configuration [ backup | main ]
1-10