Am Trap Enable - 3Com 5500G-EI Command Reference Manual

ip-pool
address-list
] & < 1-10 >
start_ip_address
ip_address_num
the range.
&< 1-10 >
Description
Use the
management on a port. The packet whose source IP address is in the specified
pool is allowed to be forwarded on Layer 3 via the port of the switch.
Use the
the port.
By default, all the IP address pools for access control on the port are null and all
the packets are permitted through.
Note that if the IP address pool to be configured contains the IP addresses
configured in the static ARP at other ports, then the system prompts you to delete
the static ARP to make the later binding effective.
Example
To configure the access management IP address pool on Ethernet1/0/1 and
permits the addresses from 202.112.66.2 through 202.112.66.20 and the
specified 202.112.65.1 to access the port, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]interface gigabitethernet 1/0/1
[SW5500-GigabitEthernet1/0/1]am ip-pool 202.112.66.2 19 202.112.65.1

am trap enable

Syntax
am trap enable
undo am trap enable
View
System View
Parameter
None
Description
Use the
function.
Enter to configure IP address pool for access management.
Enter IP address list in the
format.
is the start address of an IP address range in the pool.
specifies how many IP addresses following
means you can specify ten IP address ranges at most.
command to configure the IP address pool for access
am ip-pool
command to cancel the access management IP pool of
undo am ip-pool
command to enable the access management trap
am trap enable
Access Management Configuration Commands
start_ip_address
125
ip_address_num
[
in
start_ip_address