Administering Snmp Trap Reporting - 3Com SuperStack II 3300 User Manual

Switch layer 3 module
Table of Contents

Advertisement

46
C
6: S
HAPTER
ETTING
Administering
SNMP Trap
Reporting
Displaying Trap
Reporting
Information
Configuring Trap
Reporting
SNMP
S
P
AND
YSTEM
ARAMETERS
Enter new read-only community [public]:
Enter new read-write community [private]: secret
You can only change the community strings if you are logged into the
user interface as administrator.
For network management applications, you can manually administer the
trap reporting address information.
To display trap reporting information, including the various SNMP traps
and their current configured destinations, enter the following at the
top-level menu:
snmp trap display
The following example shows a trap settings display:
You can define up to 10 destination addresses and modify the set of traps
that are sent to each destination address.
To configure trap reporting:
1 Enter the following at the top-level menu:
snmp trap addModify
The following prompt is displayed:
Enter the trap destination address:
2 Enter the IP address of the SNMP manager (destination address).
Enter the trap numbers to enable (1-4|all) [all]:
3 Enter one or more trap numbers or
Separate a series of more than two trap numbers with a hyphen (-) and
nonsequential trap numbers by commas.
for that destination.
all

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Superstack ii 1100

Table of Contents