Motorola PowerQUICC II MPC8280 Series Reference Manual page 1198

AAL2 Receiver
Table 33-8 describes the CPS RxBD fields.
.
Offset Bits Name
0x00 0 E
1 CM
2 W
3 I
4-6 —
7 UP
8-15 CPS Packet
Header
0x02 — CPS Packet
Header
0x04 — RXDBPTR
1
Boldfaced entries must be initialized by the user.
33.4.4.5 CPS Switch Rx Queue Descriptor
The switch RxQD, shown in Figure 33-18, is used for CIDs that are being switched from
one PHY | VP | VC
1 1 1
pointer to the TxQD that controls the TxBD table through which the packet is transferred.
The switch RxQD also contains the translation CID that is saved with the packet in the
transmit buffer. A PPD mode enables the discarding of the rest of an SSSAR frame when a
buffer is not available.
33-30
Freescale Semiconductor, Inc.
Table 33-8. CPS RxBD Field Descriptions
1
Buffer empty bit
0 The CPS RX buffer is full or data reception was aborted due to an error. The core
can read or write any fields of this RxBD. The CP does not use this BD while E
remains zero.
1 The CPS RX buffer is empty or reception is in progress. This is controlled by the CP.
Once E is set, the core should not access any fields of this buffer.
Continuous mode
0 Normal operation
1 The CP does not clear E after this BD is closed, allowing the associated buffer to
be reused automatically when the CP next accesses this BD. However, the E bit is
cleared if an error occurs while receiving, regardless of the CM bit setting.
Wrap (final BD in table)
0 This is not the last BD in the RxBD table.
1 This is the last BD in the RxBD table of this current channel. After this buffer has
been used, the CP receives incoming data for this channel into the first BD in the
table. The number of RxBDs in this table is programmable and is determined only
by the W bit. The current table cannot exceed 64 Kbytes.
Interrupt
0 The CP will not issue an interrupt after this buffer is serviced.
1 The CP will issue an interrupt after this buffer is serviced if the RBM bit in the RxQD
is set.
Reserved, should be cleared during initialization.
Uncompleted packet
0 No error occurred in this packet
1 A receive error occurred that caused this packet to be uncompleted. The receive
error type is reported to the interrupt queue.
Contains the beginning of the packet header. See Figure 33-10 for the CPS packet
header format.
Contains the rest of the packet header. The CP checks the packet HEC and if
appropriate, indicates a packet HEC error in an interrupt queue entry with CID = 0.
See Figure 33-10 for the CPS packet header format.
Rx data buffer pointer. Points to the address of the associated buffer. There are no
byte-alignment requirements for the buffer, and it may reside in either internal or
external memory. This value is not modified by the CP.
| CID to another PHY
1
MPC8280 PowerQUICC II Family Reference Manual
For More Information On This Product,
Go to: www.freescale.com
Description
| VP | VC | CID . The RxQD contains the
2 2 2 2
MOTOROLA