Hvac Air Filter (If Equipped) Inspection; Hvac Air Filter (If Equipped) Replacement; Final Inspection For Maintenance Service - Suzuki Swift Sport 2004 Service & Repair Manual

0B-12 Maintenance and Lubrication:

HVAC Air Filter (If Equipped) Inspection

1) Remove HVAC air filter from HVAC unit referring to
"HVAC Air Filter Removal and Installation (If
Equipped) in Section 7A".
2) Check for dirt and dust. If HVAC air filter is
excessively dirty, replace HVAC air filter with new
one. If not, go to next step.
3) Blow compressed air on the air outlet side of HVAC
air filter for removing dust.
4) Install HVAC air filter into HVAC unit referring to
"HVAC Air Filter Removal and Installation (If
Equipped) in Section 7A".

HVAC Air Filter (If Equipped) Replacement

Replace HVAC air filter with new one referring to "HVAC
Air Filter Removal and Installation (If Equipped) in
Section 7A".

Final Inspection for Maintenance Service

WARNING
!
When carrying out road tests, select a safe
place where no man or no running vehicle is
seen so as to prevent any accident.
Seats
Check that seat slides smoothly and locks securely at
any position. Also check that reclining mechanism of
front seat back allows it to be locked at any angle.
Seat Belt
Inspect belt system including webbing, buckles, latch
plates, retractors and anchors for damage or wear.
Check that seat belt is securely locked. If "REPLACE
BELT" label on seat belt is visible, replace belt.
Battery Electrolyte Level Check
Check that the electrolyte level of all battery cells is
between the upper and lower level lines on the case. If
battery is equipped with built-in indicator, check battery
condition by the indicator.
Accelerator Pedal Operation
S7RS0B0206032 Check that pedal operates smoothly without getting
caught or interfered by any other part.
Engine Start
Check engine start for readiness.
WARNING
!
Before performing the following check, be
sure to have enough room around the
vehicle. Then, firmly apply both the parking
brake and the regular brakes. Do not use the
accelerator pedal. If the engine starts, be
ready to turn off the ignition promptly. Take
these precautions because the vehicle could
move without warning and possibly cause
personal injury or property damage.
On automatic transaxle vehicles, try to start the engine in
each select lever position. The starting motor should
crank only in "P" (Park) or "N" (Neutral).
I4RS0A020018-01
On manual transaxle vehicles, place the shift lever in
"Neutral," depress clutch pedal fully and try to start.
On Automated Manual Transaxle vehicles, try to start
the engine in each select lever position. The starting
motor should crank only when select lever is in "N"
(Neutral) and brake pedal is depressed.
S7RS0B0206033
Exhaust System Check
Check for leakage, cracks or loose supports.
Clutch (for Manual Transaxle)
Check for the following.
S7RS0B0206034
• Clutch is completely released when depressing clutch
pedal,
• No slipping clutch occurs when releasing pedal and
accelerating.
• Clutch itself is free from any abnormal condition.
Gearshift or Select Lever (Transaxle)
Check gear shift or select lever for smooth shifting to all
positions and for good performance of transaxle in any
position.
With automatic transaxle or Automated Manual
Transaxle equipped vehicle, also check that shift
indicator indicates properly according to which position
select lever is shifted to.
With automatic transaxle equipped vehicle, make sure
that vehicle is at complete stop when shifting select lever
to "P" range position and release all brakes.