Power Optimization In Run Mode - ST STM32L4x6 Reference Manual

RM0351
the sequence of injected conversions finishes, the continuous regular conversions start
again if RCONT is still set (and RPEND bit will signalize the delayed start on the first regular
conversion result).
Precedence also matters when actions are initiated by the same write to DFSDM, or if
multiple actions are pending at the end of another action. For example, suppose that, while
an injected conversion is in process (JCIP=1), a single write operation to DFSDMx_CR1
writes '1' to RSWSTART, requesting a regular conversion. When the injected sequence
finishes, the precedence dictates that the regular conversion is performed next and its
delayed start is signalized in RPEND bit.
21.3.18

Power optimization in run mode

In order to reduce the consumption, the DFSDM filter and integrator are automatically put
into idle when not used by conversions (RCIP=0, JCIP=0).
21.4 DFSDM interrupts
In order to increase the CPU performance, a set of interrupts related to the CPU event
occurrence has been implemented:
•
End of injected conversion interrupt:
–
–
–
–
•
End of regular conversion interrupt:
–
–
–
–
•
Data overrun interrupt for injected conversions:
–
–
–
–
• Data overrun interrupt for regular conversions:
–
–
–
–
•
Analog watchdog interrupt:
enabled by JEOCIE bit in DFSDMx_CR2 register
indicated in JEOCF bit in DFSDMx_ISR register
cleared by reading DFSDMx_JDATAR register (injected data)
indication of which channel end of conversion occurred, reported in JDATACH[2:0]
bits in DFSDMx_JDATAR register
enabled by REOCIE bit in DFSDMx_CR2 register
indicated in REOCF bit in DFSDMx_ISR register
cleared by reading DFSDMx_RDATAR register (regular data)
indication of which channel end of conversion occurred, reported in
RDATACH[2:0] bits in DFSDMx_RDATAR register
occurred when injected converted data were not read from DFSDMx_JDATAR
register (by CPU or DMA) and were overwritten by a new injected conversion
enabled by JOVRIE bit in DFSDMx_CR2 register
indicated in JOVRF bit in DFSDMx_ISR register
cleared by writing '1' into CLRJOVRF bit in DFSDMx_ICR register
occurred when regular converted data were not read from DFSDMx_RDATAR
register (by CPU or DMA) and were overwritten by a new regular conversion
enabled by ROVRIE bit in DFSDMx_CR2 register
indicated in ROVRF bit in DFSDMx_ISR register
cleared by writing '1' into CLRROVRF bit in DFSDMx_ICR register
DocID024597 Rev 3
Digital filter for sigma delta modulators (DFSDM)
627/1693
657