I2C Clock Requirements - ST STM32L4x6 Reference Manual

Table of Contents

Advertisement

Inter-integrated circuit (I2C) interface
The I2C is clocked by an independent clock source which allows to the I2C to operate
independently from the PCLK frequency.
This independent clock source can be selected for either of the following three clock
sources:
PCLK1: APB1 clock (default value)
HSI16: internal 16 MHz RC oscillator
SYSCLK: system clock
Refer to
I2C I/Os support 20 mA output current drive for Fast-mode Plus operation. This is enabled
by setting the driving capability control bits for SCL and SDA in
external interrupt configuration register 1 (SYSCFG_EXTICR1)
35.4.2

I2C clock requirements

The I2C kernel is clocked by I2CCLK.
The I2CCLK period t
t
I2CCLK < (tLOW - tfilters ) / 4 and
with:
t
LOW: SCL low time and tHIGH : SCL high time
t
when enabled, sum of the delays brought by the analog filter and by the digital filter.
filters:
Analog filter delay is maximum 260 ns. Digital filter delay is DNF x t
The PCLK clock period t
t
PCLK < 4/3 tSCL
with t
SCL: SCL period
Caution:
When the I2C kernel is clocked by PCLK. PCLK must respect the conditions for t
35.4.3
Mode selection
The interface can operate in one of the four following modes:
Slave transmitter
Slave receiver
Master transmitter
Master receiver
By default, it operates in slave mode. The interface automatically switches from slave to
master when it generates a START condition, and from master to slave if an arbitration loss
or a STOP generation occurs, allowing multimaster capability.
Communication flow
In Master mode, the I2C interface initiates a data transfer and generates the clock signal. A
serial data transfer always begins with a START condition and ends with a STOP condition.
Both START and STOP conditions are generated in master mode by software.
1110/1693
Section 6: Reset and clock control (RCC)
must respect the following conditions:
I2CCLK
t
I2CCLK < tHIGH
must respect the following condition:
PCLK
for more details.
DocID024597 Rev 3
RM0351
Section 8.2.3: SYSCFG
.
I2CCLK
I2CCLK
.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the STM32L4x6 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Table of Contents

Save PDF