Cam-Acl (Exec Privilege); Cam-Acl-Egress - Dell Force10 S4810P Reference Manual

Usage
You must save the new CAM settings to the startup-config (write-mem or copy run
Information
start) then reload the system for the new settings to take effect.
The total amount of space allowed is 16 FP Blocks. System flow requires three blocks and
these cannot be reallocated. The ipv4acl profile range is 1 to 4.
When configuring space for IPv6 ACLs, the total number of Blocks must equal 13.
On the S4810, there can be only one odd number of Blocks in the CLI configuration; the other
Blocks must be in factors of 2. For example, a CLI configuration of 5+4+2+1+1 Blocks is not
supported; a configuration of 6+4+2+1 Blocks is supported.
Ranges for the CAM profiles are 1 to 10, except for the ipv6acl profile which is 0 to 10. The
ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10).
If allocation values are not entered for the CAM regions, the value is 0.
If BMP 3.0 is enabled, use the command reload conditional nvram-cfg-change
to perform a reload on the chassis to upgrade any configuration changes that have changed
the NVRAM content.

cam-acl (EXEC Privilege)

Adjust the linecard CAM setting to match chassis settings.
NOTE: This command is deprecated as of FTOS 8.3.1.0.
C-Series, S-Series
Syntax cam-acl {chassis |linecard}
Command Modes EXEC Privilege
Command History
Version 8.3.1.0
Version 7.8.1.0

cam-acl-egress

Allocate CAM for egress ACLs.
S-Series (S60), Z-Series, S4810
Syntax cam-acl-egress default | l2acl
Parameters
default
l2acl
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
COMMAND DEPRECATED
Introduced on the C-Series.
Reset egress CAM ACL entries to default settings.
number
Allocate space for Layer 2 egress ACL. The range is 1 to 4 FP blocks.
Introduced on the Z9000.
573