Cam-Acl-Egress - Dell S6000 Reference Manual

Command line for the system

Hide thumbs Also See for S6000:

Table of Contents

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.4.

Version 9.2(0.2)

Version 9.1.

Version 8.3.11.1

Version 8.3.1.0

Version 8.2.1.0

Version 7.8.1.0

Save the new CAM settings to the startup-config (write-mem or copy run

start) then reload the system for the new settings to take effect.

The total amount of space allowed is 16 FP Blocks. System flow requires three

blocks; these blocks cannot be reallocated. Only 13 number of blocks can be

configured by the user .

The ipv6acl allocation must be a factor of 2.

If allocation values are not entered for the CAM regions, the value is 0.

If you enable BMP 3.0, to perform a reload on the chassis to upgrade any

configuration changes that have changed the NVRAM content, use the command

reload conditional nvram-cfg-change.

cam-acl-egress

Allocate CAM for egress ACLs.

cam-acl-egress default | l2acl number ipv4acl number ipv6acl

Content Addressable Memory (CAM)

Added support for PBR and VRF.

Added support for fcoe.

Added support for OpenFlow.

Introduced on the S4820T.

Introduced on the Z9000.

Clarified block information for the S4810.

Introduced on the S4810.

Added the keywords ecfmacl, vman-qos, and vman-dual-

Introduced on the S-Series.

Introduced on the C-Series.