Cam-Acl-Egress - Dell C9000 Series Reference Manual

There can be only one odd number of Blocks in the CLI configuration; the other Blocks
must be in factors of 2. For example, a CLI configuration of 5+4+2+1+1 Blocks is not
supported; a configuration of 6+4+2+1 Blocks is supported.
The ipv6acl allocation must be a factor of 2.
If allocation values are not entered for the CAM regions, the value is 0.
If you enable BMP, to perform a reload on the chassis to upgrade any configuration
changes that have changed the NVRAM content, use the command reload
conditional nvram-cfg-change.

cam-acl-egress

Allocate CAM for egress ACLs.
C9000 Series
Syntax
cam-acl-egress default | l2acl number ipv4acl number ipv6acl
number}
Parameters
default
l2acl number
ipv4acl number
ipv6acl number
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.10(0.0)
9.9(0.0)
9.2(1.0)
8.3.19.0
Reset egress CAM ACL entries to default settings.
Allocate space to each CAM region.
Enter the CAM profile name then the amount of CAM space to
be allotted. The total space allocated must equal 13. The range
for ipv4acl is from 1 to 4. The ipv6acl range must be a factor of
2.
Description
Introduced the Configuration Terminal Batch mode on C9010.
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Content Addressable Memory (CAM) 647