Isdn Configuration Commands; Bandwidth; Deactive-Protect (Isdn Bri Interface View) - HP MSR series Command Reference Manual

ISDN configuration commands

The MSR 900 and MSR 93X (except the JG597A) routers do not support ISDN BRI interfaces.

bandwidth

Use bandwidth to set the intended bandwidth for an ISDN BRI interface.
Use undo bandwidth to restore the default.
Syntax
bandwidth bandwidth-value
undo bandwidth
Views
ISDN BRI interface view
Default command level
2: System level
Parameters
bandwidth-value: Specifies the intended bandwidth in the range of 1 to 4294967295 kbps.
Usage guidelines
You can obtain the intended bandwidth of an interface by using third-party software to query the value
of the MIB ifspeed.
The intended bandwidth of an interface is for the network management system to monitor the interface
bandwidth, and does not affect the actual bandwidth of the interface.
Examples
# Set the intended bandwidth to 1000 kbps for ISDN BRI interface BRI 2/0.
<Sysname> system-view
[Sysname] interface bri 2/0
[Sysname-Bri2/0] bandwidth 1000

deactive-protect (isdn bri interface view)

Use deactive-protect to enable deactivation protection for the ISDN BRI Interface.
Use undo deactive-protect to disable deactivation protection for the ISDN BRI Interface.
Syntax
deactive-protect
undo deactive-protect
Default
Deactivation protection is enabled for an ISDN BRI interface.
64