Ppp Interface Configuration Command Set - HP ProCurve 7102dl Reference Manual

SROS Command Line Interface Reference Guide
PPP I
NTERFACE
To activate the PPP Interface Configuration mode, enter the interface ppp command at the Global
Configuration mode prompt. For example:
ProCurve>enable
ProCurve#configure terminal
ProCurve(config)#interface ppp 1
ProCurve(config-ppp 1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
description <text>
do on page 1435
end on page 1436
exit on page 1437
ping <address> on page 1438
shutdown on page 1442
All other commands for this command set are described in this section in alphabetical order.
access-policy <policyname>
alias link<"text">
backup commands
bandwidth <value>
bridge-group <group#>
crypto map <mapname>
dynamic-dns on page 1092
fair-queue <threshold>
hold-queue <queue size> out
ip commands begin on page 1096
keepalive <seconds>
lldp receive on page 1125
lldp send [management-address l port-description l system-capabilities l system-description l
system-name] on page 1126
lldp send-and-receive
5991-2114
C
ONFIGURATION
on page 1434
on page 1068
on page 1069
begin on page 1070
on page 1087
on page 1088
on page 1090
on page 1094
on page 1095
on page 1124
on page 1127
© Copyright 2007 Hewlett-Packard Development Company, L.P.

PPP Interface Configuration Command Set

C S
OMMAND ET
on page 1431
1066