HP ProCurve 7102dl Reference Manual page 1074

SROS Command Line Interface Reference Guide
backup backup-delay <seconds>
Use the backup backup-delay command to configure the amount of time the router will wait after the
failure condition is recognized before attempting to backup the link. Use the no form of this command to
return to the default value. For more detailed information on PPP backup functionality, refer to the
Functional Notes section of the command backup call-mode <role> on page 1073.
Syntax Description
<seconds>
Default Values
By default, the backup-delay period is set to 10 seconds.
Usage Examples
The following example configures the SROS to wait 60 seconds (on an endpoint with an active alarm
condition) before attempting backup operation:
ProCurve(config)#interface ppp 1
ProCurve(config-ppp 1)#backup backup-delay 60
5991-2114
Specifies the delay period (in seconds) a failure must be active before the SROS
will enter backup operation on the interface (valid range: 10 to 86400 seconds).
© Copyright 2007 Hewlett-Packard Development Company, L.P.
PPP Interface Configuration Command Set
1072