Cable Connection; Analog 2Mc Cable Connection - NEC Univerge sv8500 Manual

4.2.3

Cable Connection

Analog 2MC Cable Connection

This section shows the cable connection to the Analog 2MC. The MC provides the following interface types:
• Connection to LAN
• Connection of Analog Telephone/G3 Fax Machine
• Power Supply
• Serial Port Connection to Maintenance Console
Connect the required cables according to the system configuration as shown in the following figure.
Analog 2MC
(Rear View)
Analog
Telephone
FAX
Maintenance Console
(PC)
Note: Depending on the network configuration, install a Switching HUB/Router for connecting the MC to an IP
network
Note 1: To connect to AC source, use an attached three-polar grounded AC power cable.
(Cable Length: 3 m [9.8 ft.])
Analog 2MC Cable Connection
RJ-11 Connector
Pin Assignment
4 Not Used
3 A
2 B
1 Not Used
RS-232C
Analog 1
Analog 0
D-Sub 9-Pin
Straight-through Cable
LAN Cable
(10BASE-T/100BASE-TX)
VOL.2-54
Analog 2MC (Analog Media Converter)
RJ-45 Connector
Pin Assignment
8 Not Used
7 Not Used
6 RD -
5 Not Used
4 Not Used
3 RD +
2 TD -
1 TD +
POWER AC IN
Ether
To AC source Note 1
LAN Cable (10BASE-T/100BASE-TX)
Switch
D term IP
Telephony Server