NEC Univerge sv8500 Manual page 317

• When DHCP server is used
As MC automatically gets IP address from DHCP server, IP address setting is not required on MC. Assign the
IP address listed below on DHCP server side.
• IP address of Default Gateway
• IP address of DRS
Assign the following data on MC from the maintenance terminal:
1.
Change DHCP setting to ENABLE.
2. Assign other data to be changed from the default such as PAD value.
3. Save the data change to the Flash ROM (
4. Reboot the MC. (
5. Exit from the maintenance command.
Check the number of IP addresses saved in DHCP server is sufficient so as to get IP address of MC any
Note 1:
time.
Assign DHCP option on DHCP server as follows.
Note 2:
Name: Not specified, but do not enter the same option name in duplicate
Data: IP address
Array: Checked
Code: 161
About IP address of DRS (Telephony Server), refer to "Registration Destination of IP Devices/Stations"
Note 3:
in INTRODUCTION of Installation Manual.
Note 1
Note 3
(
SET DHCP ENABLE
SAVE CONFIGDATA
)
REBOOT
Analog 2MC (Analog Media Converter)
Note 2
,
)
)
VOL.2-64