Neighbor Filter-List - Dell Z9500 Command Reference Manual

Related show ip bgp neighbors
Commands

neighbor filter-list

Configure a BGP filter based on the AS-PATH attribute.
Z9500
Syntax
neighbor {ipv6-address | peer-group-name} filter-list as-path-
name {in | out}
To delete a BGP filter, use the no neighbor {ipv6-address | peer-group-
name} filter-list as-path-name {in | out} command.
Parameters
ipv6-address
peer-group-
name
as-path-name
in
out
Defaults Not configured.
Command ROUTER BGPV6-ADDRESS FAMILY
Modes
Command
Version
History
9.2(1.0)
8.2.1.0
7.4.1.0
neighbor maximum-prefix
Control the number of network prefixes received.
Z9500
Syntax
neighbor {ipv6-address | peer-group-name} maximum-prefix
maximum [threshold] [warning-only]
Border Gateway Protocol
– displays information on the BGP neighbors.
Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
Enter the name of the peer group to apply the filter to all
routers in the peer group.
Enter the name of an established AS-PATH access list. If you
do not configure the AS-PATH access list, the default is
permit (to allow routes). The maximum is 16 characters.
Enter the keyword in to filter inbound BGP routes.
Enter the keyword out to filter outbound BGP routes.
Description
Introduced on the Z9500.
Introduced on the E-Series ExaScale.
Introduced
543