Neighbor Soft-Reconfiguration Inbound - Dell Z9500 Command Reference Manual

To disable sending a COMMUNITY attribute, use the no neighbor {ipv6-
address | peer-group-name} send-community command.
Parameters
ipv6-address
peer-group-
name
Defaults Not configured and COMMUNITY attributes are not sent to neighbors.
Command ROUTER BGPV6-ADDRESS FAMILY
Modes
Command
Version
History
9.2(1.0)
8.2.1.0
7.4.1.0

neighbor soft-reconfiguration inbound

Enable a BGP soft-reconfiguration and start storing updates for inbound IPv6 unicast routes.
Z9500
Syntax
neighbor {ipv4-address | ipv6-address | peer-group-name} soft-
reconfiguration inbound
Parameters
ipv4-address |
ipv6-address
peer-group-
name
Defaults Disabled.
Command ROUTER BGPv6 ADDRESS FAMILY (conf-router_bgpv6_af)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
552
Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
Enter the name of the peer group to send a COMMUNITY
attribute to all routers within the peer group.
Description
Introduced on the Z9500.
Introduced on the E-Series ExaScale.
Introduced
Enter the IP address of the neighbor for which you want to
start storing inbound routing updates.
Enter the name of the peer group for which you want to start
storing inbound routing updates.
Border Gateway Protocol