Show Cam-Acl - Dell Z9500 Command Reference Manual

Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.2.1.0
7.8.1.0
Usage When you enable this command, if a Policy Map containing classification rules (ACL
Information and/or dscp/ ip-precedence rules) is applied to more than one physical interface
on the same port pipe, only a single copy of the policy is written (only one FP entry
is used).

show cam-acl

Display the details of the CAM profiles on the chassis and all line cards.
Z9500
Syntax
show cam-acl
Defaults none
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.2(1.0)
Content Addressable Memory (CAM)
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
NOTE: An ACL itself may still require more that a single FP entry, regardless of
the number of interfaces. For more information, refer to the "IP Access
Control Lists", "Prefix Lists", and "Route-map" sections in the Dell Networking
OS Configuration Guide.
Description
Added support for nlbcluster show command output.
Introduced on the Z9500.
583