Show Ipv6 Neighbors - Dell Z9500 Reference Manual

show ipv6 neighbors

Display IPv6 discovery information. Entering the command without options shows all IPv6 neighbor
addresses stored on the control processor (CP).
Z9500
Syntax
show ipv6 neighbors [vrf vrf-name] [cpu rp [ipv6–address]
[ipv6-address| interface interface]
Parameters
vrf vrf-name
cpu rp
ipv6–address
ipv6-address
interface
interface
Defaults none
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
IPv6 Basics
(OPTIONAL) Enter the keyword vrf followed by the name of
the VRF to display the neighbors corresponding to that VRF.
Enter the keywords cpu rp to display information about
IPv6 neighbors learned only on the Route Processor.
Enter the IPv6 address of a neighbor to display information
about the specified device.
Enter the IPv6 address of the neighbor in the x:x:x:x::x
format.
Enter the keyword interface then the interface type and
slot/port or number information:
• For a port channel interface, enter the keywords port-
channel then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
EXEC
EXEC Privilege
NOTE: If you do not specify this option, neighbors
corresponding to the default VRF are displayed.
NOTE: The :: notation specifies successive hexadecimal
fields of zero.
1009