Network Backdoor - Dell Z9500 Command Reference Manual

Version
8.2.1.0
7.4.1.0
Usage The software resolves the network address configured by the network command
Information
with the routes in the main routing table to ensure that the networks are reachable
via non-BGP routes and non-default routes.
Related redistribute
Commands

network backdoor

Specify this IGP route as the preferred route.
Z9500
Syntax
network ipv6-address prefix-length backdoor
To remove a network, use the no network ipv6-address prefix-length
backdoor command.
Parameters
ipv6-address
prefix-length
Defaults Not configured.
Command ROUTER BGPV6-ADDRESS FAMILY
Modes
Command
Version
History
9.2(1.0)
8.2.1.0
7.4.1.0
Usage Though the software does not generate a route due to backdoor config, there is an
Information option for injecting/ sourcing a local route in presence of network backdoor config
on a learned route.
Border Gateway Protocol
Description
Introduced on the E-Series ExaScale.
Introduced
– redistributes routes into BGP.
Enter the IPv6 address in the x:x:x:x::x format followed by the
prefix length in the /x format. The r range is /0 to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
Description
Introduced on the Z9500.
Introduced on the E-Series ExaScale.
Introduced
559