Table of Contents
Advertisement
230 V
115 V
Removal of the combined switch / fuse holder unit
Remove here
Installation
6.5.1 Connecting to the mains
!
Only attach the units to mains sockets with a
grounded earth. Compare the local mains voltage
with the specifications written on the name plates
of the measuring instrument and the control unit.
Voltage deviations of 10% are permissible.
Before connecting the HAAKE MiniJet Pro to the power sup-
ply, it is essential to carry out the following steps:
Check that the casing of the HAAKE MiniJet Pro shows
no visible signs of damage.
It is essential to check whether the selected voltage
corresponds with that of the electricity mains.
To replace the fuses for the appropriate supply voltage
(220--240 V -- 6.3 A; 100--120 V -- 10 A) note the follo-
wing points:
Pull the mains cable out of the connecting socket on the
1
rear of the unit.
With the help of a small flat screwdriver, release the in-
2
sert from the connecting socket.
Fuses are not in the
scope of delivery.
Place the insert back with the selected fuses for the
3
power supply on again.
Use the mains cable according to your local mains volt-
age.
11
An additional fuse mark on the
switch indicates the fuses holders
behind the switch. The red frame
shows the outline of the removable
unit.
With a simple tool like a Swiss Army
knife or a screwdriver No 1 or smaller
the unit (1) can be removed from the
filter. On the topside (2) behind the
switch there are two fuse holders for
each live connection. On the bottom
side (3) is a clip to carry an additional
spare fuse.
Advertisement
Table of Contents
