Table of Contents
Advertisement
Section 3
Installation
Connecting to the
Mains Power Supply
Plate Installation
3-2
MicroPlate Shaker
Connect the electric power to the unit according to the following process.
STEP 1: Switch off the main switch before connecting AC power cable.
STEP 2: Connect the power cable to the socket located on the unit back.
• Check voltage, phase, volume of power and connect properly.
• Power source must be grounded.
• Cable could be damged by overcurrent and may cause fore. So do not use a
branch socket or double taps.
Slide and insert Microplate to the direction of the fixing rubber as below.
Operate after inserting four Microplates for balancing. If you insert two
Microplates, install them diagonally.
Likewise, when you remove the plate, push the outside home of the plate
tray to the direction of the fixing rubber. Lift and remove it.
1
2
3
1
2
Thermo Scientific
Advertisement
Table of Contents
